This listing closed and did not sell. The item has been relisted.
- Browse for similar listings in Sensors
- View the relisted item
Other listings you might like
Description
Features: Use on lerdge board: the green light for the module is always on when material is available. When the material is used up, the green light goes out. The main board executes the pause command operation and waits for the personnel to replace the good material and then continues to print. Lerdge main board wiring: M sensor port on the main board. For other boards: material detection module uses level jump detection method. When there is material, the level signal of the detection port should be high. When there is no material, the level signal of the material port becomes low, and the system detects one. If the high to low conversion is determined, the material is considered exhausted and the pause command is executed. After humans change the material, the printer continues to print. Suitable for 3D printer run-out, pause detection.
Specification: Condition: 100% brand new Material: ABS Color: as picture shown
Package list: 1 x Filament Detecting Module 1 x Connecting Line
Note: Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering. The delivery time is around 10-20 working days after your purchase
Details
Shipping & pick-up options
Destination & description | Price | |
---|---|---|
Nationwide 13-20 days, Economy | $6.89 | |
Shipping more than one item | No extra charge |
Estimated delivery times in business days
Pick-ups not available
GST included.
Payment Options
Pay instantly by card, Ping balance or saved bank account.
Four fortnightly interest-free payments.